기기를 수리하세요 커뮤니티 상점

The Arduino Uno is an open-source microcontroller board based on the Microchip ATmega328P.

2 질문 전체 보기

옵션

This isn’t really a repair I just need someone with some experience

Block Image

This morning I accidentally fried my R3 I don’t know how, it was hooked up to the 9V battery and it was running blink as a test suddenly the lights went out and the 47uf capacitors started getting hot. So it’s time for an upgrade I have the R4 on its way but is there any way to get the R3 temporarily working

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 2
댓글 2개

It might be a blown capacitor, can you check?

의

@ryan0001 idk how also I don’t have a volt meter available I believe I blew a fuse and that is causing them to get hot

의

댓글 달기

답변 1개

필터:
가장 유용함 가장 최근 가장 오래된
선택된 답변

옵션

@thomas35549 a blown fuse would not cause this, If anything I would suspect the voltage regulator U1 (AMS1117) next to your DC In Jack.

Block Image

Here is the layout Uno 3 Component Layout and here is the schematic Uno 3 Schematic The datesheet for the voltage regulator is here AMS1117

해당 답변은 도움이 되었습니까?

예 아니요
점수 1

댓글 1개:

Ok thank you

의

댓글 달기

귀하의 답변을 추가하세요

Thomas 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 2

30일 전: 9

전체 시간: 50