주요 콘텐츠로 건너뛰기

4세대 iPhone의 CDMA 버전. 수리는 간단하지만 앞면 유리와 LCD를 하나의 유닛으로 교체해야 합니다. 16 또는 32GB / Model A1349 / CDMA 호환성.

295 질문 전체 보기

Wont charge after screen repair

I replaced the touch screen and back panel. The iPhone worked fine before it just had a cracked touch screen. after replacing the broken screen the phone works great however, it wont charge or recognize itunes when plugged into the computer. I have power cycled the phone, opened it up again and made sure all the connections are clean and plugged in properly and it still wont charge. If the phone is off when I plug it in it will turn on but wont show that it is charging. The only thing I can guess (after looking online) that is wrong it a fuse may have blown during the repair. When I removed the batter the first time I did notice a tiny spark by the connection, but I could see no damage and the phone works properly in all aspects except charging.

Any suggestions?

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 -1
댓글 달기

답변 3개

선택된 답변

Sparks are never good. Possibly a solder pad lifted between the battery connector leads and the Logic Board. If this is the case it could be a simple solder job, or a very complex procedure with bypass wires needed.

해당 답변은 도움이 되었습니까?

점수 2
댓글 달기

Double check that your dock connector is plugged in all the way. Here is a link to the dock connector guide.

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

i've got the same problem - replacement screen worked fine after the repair but when the battery ran down it just wouldn't charge. Usual sign when I switch on of low battery and insert charging cable screen, but nothing happens when I insert th cable - have checked the connections and they all seem fine and I was careful when I disconnected the battery.

Very annoying - any tips welcomed....

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

귀하의 답변을 추가하세요

Clark 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 4,456