Asus ROG G20CB RAM Replacement

수리 커뮤니티 가입 - 계정 만들기

소개

Upgrading or replacing the RAM (memory) on the Asus ROG G20CB can help boost system performance, especially for gaming, multitasking, or professional workloads.This guide will walk you through how to safely access, remove, and install RAM in the G20CB's compact chassis.

Important:

The G20CB uses DDR4 SODIMM (laptop-style) RAM, not standard desktop DIMMs.
Maximum supported memory depends on your CPU and motherboard model, but generally caps around 32GB (2x16GB).

필요한 것

1 단계 Fan

Asus ROG G20CB RAM Replacement, Fan: 1 단계, 이미지 2개 중 1개

Asus ROG G20CB RAM Replacement, Fan: 1 단계, 이미지 2개 중 2개

Remove each of the two 4.6 mm Phillips screws on the top and bottom of the tower.

번역하기

2 단계

Slide the front panel to the left and lift gently.
There is a cable connecting the panel to the computer. Handle it gently and avoid straining the connected panel.

번역하기

3 단계

Disconnect the cable carefully by pulling gently on both sides of the connector.

번역하기

4 단계

Remove the five 4.6 mm Phillips screws holding down the fan tray and then pull the fan tray out of the system.
The fans are connected by a thin cable, be gentle when removing tray.

번역하기

5 단계

Carefully unplug the two fan cables from the motherboard by pulling straight up from the base of the connector.

번역하기

6 단계

Remove the six 4.6 mm Phillips screws connecting the fans to the fan tray.

번역하기

7 단계 CPU Cooler

Asus ROG G20CB RAM Replacement, CPU Cooler: 7 단계, 이미지 1개 중 1개

Remove the 4.6 mm Phillips screw that secures the optical drive.

번역하기

8 단계

Push the optical drive out of the chassis.

번역하기

9 단계

Pull back the tape on the heat sink and use a long-neck Phillips screwdriver to remove the four screws securing the heat sink.
There is a number next to each screw, when taking the cooler off, loosen in descending order (4-3-2-1). When installing a cooler, tighten in ascending order.

번역하기

10 단계

Remove the 4.6 mm Phillips screw from the heatsink at the top of the case.
Lift the CPU cooler out of the system.
Be sure to apply fresh thermal paste before reinstalling a cooler.

번역하기

11 단계 RAM

Asus ROG G20CB RAM Replacement, RAM: 11 단계, 이미지 1개 중 1개

Gently push outward on the two retaining clips on either side of the RAM stick.

번역하기

12 단계

The RAM module should pop up at an angle.
Pull the RAM stick out carefully by grasping it by the edges.
Avoid touching gold contacts.

번역하기

결론

To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.