Back Case

최종 수정일 September 11, 2020

예상시간 없음

조정

소개

Are you trying to figure out what is wrong with your camera? This is a good place to start as it allows you to access everything in the camera that could possibly be wrong.

필요한 것

도구

1 단계 Battery

Orient camera to look directly at battery compartment side as shown.

번역하기

2 단계

Locate the two latches on the battery compartment.
First, move the "lock" switch left to reveal red indicator.
Next, move the "cover latch" switch downward to reveal red indicator.
You have to move the switches in that order for the compartment to unlatch.

번역하기

3 단계

Allow the battery compartment latch to completely open.
Insert battery with the writing face up.
The bigger slot is for the battery. The smaller slot is for the memory card.
Battery not shown.

번역하기

4 단계 Back Case

Orient the camera so you are looking at the bottom.
Remove the three 3.85mm Phillips #00 screws from the bottom of the camera.

번역하기

5 단계

Orient the camera so you are looking at the side plate.
Remove the two 3.15mm Phillips #00 screws from the side plate of the camera.

번역하기

6 단계

Orient the camera so you are looking at the front plate.
Remove the two 3.8mm with the Phillips H1.5 from the front plate.
Remove the "Olympus" plate.

번역하기

7 단계

Remove face plate.

번역하기

8 단계

Locate three small black screws inside of the battery compartment.
Remove the 3.85mm Phillips #00 screw on the far left side.
Remove the two 5mm Phillips #00 screws on the right side

번역하기

9 단계

Orient the camera to be look at the top.
Remove the 5.4mm Phillips #00 screw on the top left side.
Remove the 7.4mm Phillips #00 screw next to the "ON/OFF" label.
Pry off top button plate with black nylon spudger.

번역하기

10 단계

Rotate to bottom of camera and locate bottom latch.
Wedge black nylon spudger in between bottom latch and camera base to release LCD Screen from camera.
Push firmly apart.
Some buttons might fall out.