물건을 수리하세요 커뮤니티 상점

DigiTech RP70 LED Light Replacement

소개

If the LED light is broken, or dead, this guide will teach you how to remove the broken component for replacement.

필요한 것

  1. DigiTech RP70 LED Light Replacement, Motherboard: 1 단계, 이미지 2개 중 1개 DigiTech RP70 LED Light Replacement, Motherboard: 1 단계, 이미지 2개 중 2개

    • Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.

    • Remove the four 8mm Phillips #0 screws located on the back panel.

    편집

  2. DigiTech RP70 LED Light Replacement: 2 단계, 이미지 2개 중 1개 DigiTech RP70 LED Light Replacement: 2 단계, 이미지 2개 중 2개

    • Remove the back panel to expose the motherboard.

    편집

  4. DigiTech RP70 LED Light Replacement: 3 단계, 이미지 1개 중 1개

    • Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.

    편집

  5. DigiTech RP70 LED Light Replacement: 4 단계, 이미지 1개 중 1개

    • Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.

    편집

  6. DigiTech RP70 LED Light Replacement, LED Light: 5 단계, 이미지 1개 중 1개

    • Desolder the back of the motherboard where the LED light is located.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

작성자

3다른 기여자 명과 함께

Elijah Smith

회원 가입일: 09/10/18

738 평판

안내서 6개를 작성함

배지: 10

배지 +7개 더

팀

Appalachian State University, Team S2-G2, Menagarishvili Fall 2018 Appalachian State University, Team S2-G2, Menagarishvili Fall 2018 회원

APSU-MENAGARISHVILI-F18S2G2

3 회원들

안내서 6개를 작성함

0가이드 댓글

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 6

전체 시간: 389