주요 콘텐츠로 건너뛰기

소개

Use this guide to replace the front and rear cameras in the Microsoft Surface Pro.

  1. Microsoft Surface Pro Camera Replacement, Display: 1 단계, 이미지 1/1
    • Use a heated iOpener or a heat gun to heat the edges of the display and soften its adhesive.

    • If you're using an iOpener it may take several cycles of reheating and applying it to soften the adhesive enough. Every time, let the iOpener sit on the display for at least a minute before reheating to allow the adhesive to soften.

  2. Microsoft Surface Pro Camera Replacement: 2 단계, 이미지 1/2 Microsoft Surface Pro Camera Replacement: 2 단계, 이미지 2/2
    • Apply a suction cup as close as possible to the edge of the display.

    • Use the suction cup to lift the edge of the display enough to insert an opening pick under the edge.

    • Slide the opening pick all the way around the edges of the display to cut through the adhesive on the bezel.

    • Do not insert the opening pick past the bezel of the display—you may permanently damage the display.

    • Be very careful and move slowly during this step. The display is fragile and will crack if too much force is applied against it. If your tools seem stuck, apply more heat to further soften the adhesive.

  3. Microsoft Surface Pro Camera Replacement: 3 단계, 이미지 1/2 Microsoft Surface Pro Camera Replacement: 3 단계, 이미지 2/2
    • Starting from the top edge, lift the display slightly. If you feel any resistance, use heat and an opening pick to slice through any remaining adhesive.

    • Before completely removing the display, disconnect the three display cables.

  4. Microsoft Surface Pro Camera Replacement: 4 단계, 이미지 1/1
    • Remove the display.

  5. Microsoft Surface Pro Camera Replacement, Camera: 5 단계, 이미지 1/2 Microsoft Surface Pro Camera Replacement, Camera: 5 단계, 이미지 2/2
    • Using a T5 Torx screwdriver, unscrew a total number of 23 screws located on the outside panel of the Surface Pro.

  6. Microsoft Surface Pro Camera Replacement: 6 단계, 이미지 1/1
    • Use the plastic opening tool or fingers to pry out the front camera.

  7. Microsoft Surface Pro Camera Replacement: 7 단계, 이미지 1/1
    • Lift the outside panel from the Surface Pro.

  8. Microsoft Surface Pro Camera Replacement: 8 단계, 이미지 1/2 Microsoft Surface Pro Camera Replacement: 8 단계, 이미지 2/2
    • Use the plastic opening tool to pry out the back camera.

결론

To reassemble your device, follow these instructions in reverse order.

Jonathan Choi

회원 가입일: 2013년 10월 09일

855 평판

안내서 4개 작성하였습니다

Cal Poly, Team 8-20, Regan Fall 2013 Cal Poly, Team 8-20, Regan Fall 2013 회원

CPSU-REGAN-F13S8G20

4 회원들

안내서 13개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 6

30일 전: 25

전체 시간: 3,762