소개
An unresponsive power button is a very common problem. Typically, this problem occurs when the solder between the power button and the motherboard weakens. For more information and other fixing alternatives see the link below:
필요한 것
-
-
-
Orient the device so that the display faces forward.
-
Remove the stylus from the right side.
FixBot에 문의하기
-
-
-
Turn over the device so that the back panel faces forward.
-
Use a T5 Torx screwdriver to remove the four 6.35mm corner screws.
-
-
-
Rotate the device so that the display faces forward.
-
Insert a plastic opening tool with the angled tip pointing downward into the crevice on the left side of the device.
-
Pry along the crevice to loosen the back panel.
-
Repeat this process for the right side.
-
-
-
-
-
-
Use a soldering iron to disconnect the battery wires from the motherboard.
-
For soldering instructions, you can view the Soldering Guide.
-
-
-
-
-
Pull straight up on the ribbon cables located on the bottom right of the motherboard to disconnect them.
-
-
-
-
-
Flip the motherboard so that the black rubber cover faces upward. The power switch is in the top right corner.
-
Remove the button with a soldering iron.
-
For soldering instructions, view the Soldering Guide.
-
-
To reassemble your device, follow these instructions in reverse order.
팀
Cal Poly, Team 1-15, Amido Winter 2011 Cal Poly, Team 1-15, Amido Winter 2011 회원
CPSU-AMIDO-W11S1G15
4 회원들
안내서 35개를 작성함
