#6단계의 변경 사항
편집자 Jeremy Mikesell-
편집 승인됨 완료자 Jeremy Mikesell
- 이전
- 이후
- 변경 사항 없음
단계 라인
| + | [title] Remove the LED emitter screw |
|---|---|
| + | [* black] The LED assembly is held in with two screws that are very hard to access. The short side of an L-handle hex key will work. slowly, 60 degrees at a time. |
| + | [* black] These screws should have lock washers under them. |
| + | [* black] The emitter has a thermal transfer material under it that will hold it in place. Break this bond by prying gently. |
이미지 1
이전 이미지 없음
추가