#13단계의 변경 사항
단계 라인
| + | [* black] There are 2 screws at the top. One that holds in the camera, and one that is holding the logic board. Remove them both. Carefully remove the rear facing camera from the case. It's the one that you removed the small shield from a few steps ago. The camera will stay attached to the logic board via a cable. I also pushed the speaker/dock connector upwards to help free it from the case. |
|---|---|
| [* black] It took a bit of prying to lift the battery and logic board out of the casing, but unfortunately the headphone/sleep button control ribbon cable is both soldered to the logic board and glued to the outer case. |