주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

도움말
10단계 편집 중 —

알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 8 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

If reusing the rear glass panel during reassembly:

Use tweezers to peel away any remaining adhesive from both the rear panel and the phone's chassis.

Clean the adhesion areas with high concentration isopropyl alcohol (at least 90%) and a lint-free cloth. Swipe in one direction only, not back and forth. This will help prep the surface for the new adhesive.

Be sure to turn on your phone and test your repair before installing new adhesive and resealing the phone.

Peel away the replacement adhesive's liner, align it with the back of the phone, and press it into place.

Remove any remaining liners, and replace the rear glass panel.

After installing the rear panel, apply strong, steady pressure to your phone for several minutes to help the adhesive form a good bond, such as by placing it under a stack of heavy books.

You can also reinstall the rear panel without replacing the adhesive. Remove any large chunks of adhesive that might prevent the panel from sitting down flush. After installation, heat the panel and apply pressure to secure it. The phone won't be waterproof, but the residual adhesive is usually more than strong enough to hold.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.