주요 콘텐츠로 건너뛰기

Reemplazo de tiras adhesivas de la pantalla de iMac Intel 21.5"

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 8개에 영향을 미칩니다.

영어
스페인어
14 단계
iMac Intel 21.5" Display Adhesive Strips Replacement: 0 단계, 이미지 3개 중 1개 iMac Intel 21.5" Display Adhesive Strips Replacement: 0 단계, 이미지 3개 중 2개 iMac Intel 21.5" Display Adhesive Strips Replacement: 0 단계, 이미지 3개 중 3개
  • The microphone hole is the center hole flanked by two larger holes.

  • Align the adhesive strip to the bottom edge by positioning the microphone notch over the microphone hole.

  • If your iMac does not have a microphone hole, align the right end of the strip such that the L-bend sits next to the right vertical adhesive. The L-bend should not overlap the right vertical adhesive.

  • The adhesive tears easily. Be careful not to pull on the strip with too much force.

  • Once you have aligned the strip, carefully set the left exposed edge onto the iMac to secure the alignment.

El agujero del micrófono es el agujero central flanqueado por dos agujeros más grandes.

Alinea la tira adhesiva con el borde inferior colocando la muesca del micrófono sobre el agujero del micrófono.

Si tu iMac no tiene un orificio para el micrófono, alinea el extremo derecho de la tira de forma que la curva en L quede junto al adhesivo vertical derecho. La curva en L no debe superponerse al adhesivo vertical derecho.

El adhesivo se rompe fácilmente. Ten cuidado de no tirar de la tira con demasiada fuerza.

Una vez que hayas alineado la tira, coloca con cuidado el borde izquierdo expuesto en la iMac para asegurar la alineación.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.