주요 콘텐츠로 건너뛰기

iPhone 6 Power Button Kabeleinheit ersetzen

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

5 단계
iPhone 6 Power Button Cable Assembly Replacement: 0 단계, 이미지 1개 중 1개
  • When you feel increased resistance from the adhesive strip, pull it gently around the lower left corner of the battery.

  • Don't allow the adhesive strip to snag on the corner of the battery, or it may tear or break off.

  • Continue pulling the adhesive tab upward and away from the left edge of the battery, allowing it to slowly slide out from between the battery and the rear case, until the strip comes free from the iPhone.

  • If you removed both adhesive strips successfully, skip the next two steps and continue on Step 46.

  • If either of the adhesive strips broke off underneath the battery and could not be retrieved, continue with the next step below.

Wenn du verstärkten Widerstand des Klebestreifens fühlst, ziehe ihn vorsichtig um die linke untere Ecke des Akkus.

Achte darauf, dass der Kleber nicht an der Ecke des Akkus hängenbleibt, da der Streifen sonst reißen könnte.

Ziehe weiter am Klebestreifen, nach oben und weg von der linken Kante, bis der Streifen sich zwischen Akku und Rückseite herausziehen lässt.

Wenn du beide Klebestreifen erfolgreich entfernt hast, überspringe die beiden nächsten Schritte und mach bei Schritt 46 weiter.

Wenn einer der Klebestreifen unter dem Akku gerissen ist und nicht entfernt werden konnte, mach mit dem nächsten Schritt weiter.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.