주요 콘텐츠로 건너뛰기

iPhone 6の電源ボタンケーブルアセンブリの交換

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

5 단계
iPhone 6 Power Button Cable Assembly Replacement: 0 단계, 이미지 1개 중 1개
  • When you feel increased resistance from the adhesive strip, pull it gently around the lower left corner of the battery.

  • Don't allow the adhesive strip to snag on the corner of the battery, or it may tear or break off.

  • Continue pulling the adhesive tab upward and away from the left edge of the battery, allowing it to slowly slide out from between the battery and the rear case, until the strip comes free from the iPhone.

  • If you removed both adhesive strips successfully, skip the next two steps and continue on Step 46.

  • If either of the adhesive strips broke off underneath the battery and could not be retrieved, continue with the next step below.

粘着タブからの抵抗感が増したと感じたら、バッテリーの左端下あたりでゆっくりと引いていきます。

バッテリーの端に粘着タブを引っかけないように気をつけましょう。タブが切れてしまうことがあります。

粘着タブをバッテリー左端の上方に向けて回すように引っ張っていきます。バッテリーと背面ケースの間からゆっくりとタブが出てきます。タブがiPhoneから完全に出たところで作業を終えます。

2つの粘着タブを無事に取り出すことができたら次の2つの手順をスキップして手順46から作業を始めてください。

粘着タブがバッテリーの下で切れてしまい、取り出すことができない場合は、この下に表示されている次のステップをご覧ください。

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.