주요 콘텐츠로 건너뛰기

iPhone 6 电源键组更换

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

5 단계
iPhone 6 Power Button Cable Assembly Replacement: 0 단계, 이미지 1개 중 1개
  • When you feel increased resistance from the adhesive strip, pull it gently around the lower left corner of the battery.

  • Don't allow the adhesive strip to snag on the corner of the battery, or it may tear or break off.

  • Continue pulling the adhesive tab upward and away from the left edge of the battery, allowing it to slowly slide out from between the battery and the rear case, until the strip comes free from the iPhone.

  • If you removed both adhesive strips successfully, skip the next two steps and continue on Step 46.

  • If either of the adhesive strips broke off underneath the battery and could not be retrieved, continue with the next step below.

当你感觉到胶带长度已经被拉到极限时,轻缓地将胶带拉到电池左边底部地方。

请勿将胶带黏到电池连接座上,因为这有可能造成断裂或电池损坏。

在撕的过程,将胶带往上拉,并让胶带慢慢地从电池与后盖间分离。

若你成功地将两边的胶带撕除,请跳过接下来的两个步骤,直接进入步骤46。

若其中一个胶带在撕的过程中断裂,并无法用以上方法继续撕的话,请继续接下来的步骤。

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.