이 사용자는 아직 프로필을 작성하지 않았습니다.
질문
IFIXIT has not included this fastest growing sector of repair issues. We have two EV bikes, one a few weeks old, and the...
더 읽어보기I have a whirlpool microwave, about 5 years old. intermittent failure to heat when the interior light goes off. That light...
더 읽어보기First, I picked the Hard Drive above not knowing what is inside the iPod, so forgive me for that as I didn't have an...
더 읽어보기I have called Whirlpool with a half-hour wait to be told that the overhead light in the refrigerator compartment, which...
더 읽어보기I found the problem but would appreciate help. A small spring which moves the next staple into position has broken. I...
더 읽어보기I had no choice in asking my question because the L'ange, an expensive hair dryer, was not listed. If anyone has had any...
더 읽어보기I opened the case and got to the battery which a Youtube video identified as the problem. In my case,the battery (looks...
더 읽어보기답변
See if this helps. I think I loaded the images correctly but never sure. PLEASE let me know if get them. I will resend if necessary. I added them to the upload icon at the ribbon on the website.
더 읽어보기I will provide you with correct voltages and let's see what happens thereafter. thanks again
더 읽어보기OK I have a meter and I will see what the ranges are and let you know. Won't I need some kind of device that will help me balance them? If so, please recommend.
더 읽어보기Hello, I have now removed the batteries from its container. Can you give me any sense of the next step? Would appreciate it if you could
더 읽어보기well i have a high and low switch so i will use the cooler leg and move away from the pack and see how it goes. Once i get it out I will lean on you for what I will need to get these batteries stable and balanced. Again, most appreciated.
더 읽어보기casing is sealed on an edge. front and back have heavy dabs of glue or sealant keeps the batteries and the circuit board in place. I will need a very sharp long knife to cut through it. Will hot air make it easier? I have to be careful of the circuit board that is integrated into the tube
더 읽어보기my bet is you shorted out the board, and if so you will need a new board, or frankly a new dryer. You may have inadvertently put a neutral and hot leg together. Anything turn black or smell like plastic burning? Do you have a meter to test for continuity?
더 읽어보기Murray L. Berkowitz
@mlb_fixit
11
평판
7
해결책
0
안내서
회원 가입일 03/11/22
투표
3
0