I cannot find a direct manufacturer's replacement battery based on the part number shown on the battery image you posted, however it is a standard 14500 3.6V battery so a compatible replacement should suffice.
Here's is just one [link|https://www.batterystore.com/14500-3-6v-850mah-lithium-ion-aa-size-rechargeable-w-wire-leads/|supplier].
-
Search for ''14500 3.6V battery with wires'' to find other suppliers that may suit you better.
+
Search for ''14500 3.6V 850 battery with wires'' to find other suppliers that may suit you better.
You may find that some have the battery but with one wire at each end and not coming out at one end only. This isn't a problem unless the wire is too short to reach the board or it means that the battery won't sit properly when fitted etc.
As for installation etc, first ''take photos of where the original battery's red and black wires are soldered onto the pcb board'' so that you have a reference of where to connect the new battery wires. Then you need to simply unsolder the wires of the old battery from the board and solder the wires from the new battery in their place.
Then partially reassemble and check if it charges OK, then disconnect and fully reassemble the trimmer and fully charge the battery before use.
I cannot find a direct manufacturer's replacement battery based on the part number on the battery image you posted, however it is a standard 14500 3.6V battery so a compatible replacement should suffice.
+
I cannot find a direct manufacturer's replacement battery based on the part number shown on the battery image you posted, however it is a standard 14500 3.6V battery so a compatible replacement should suffice.
-
Here's is just one [https://www.batterystore.com/14500-3-6v-850mah-lithium-ion-aa-size-rechargeable-w-wire-leads/|supplier].
+
Here's is just one [link|https://www.batterystore.com/14500-3-6v-850mah-lithium-ion-aa-size-rechargeable-w-wire-leads/|supplier].
Search for ''14500 3.6V battery with wires'' to find other suppliers that may suit you better.
You may find that some have the battery but with one wire at each end and not coming out at one end only. This isn't a problem unless the wire is too short to reach the board or it means that the battery won't sit properly when fitted etc.
As for installation etc, first ''take photos of where the original battery's red and black wires are soldered onto the pcb board'' so that you have a reference of where to connect the new battery wires. Then you need to simply unsolder the wires of the old battery from the board and solder the wires from the new battery in their place.
Then partially reassemble and check if it charges OK, then disconnect and fully reassemble the trimmer and fully charge the battery before use.
Hi @brettkirton
I cannot find a direct manufacturer's replacement battery based on the part number on the battery image you posted, however it is a standard 14500 3.6V battery so a compatible replacement should suffice.
Here's is just one [https://www.batterystore.com/14500-3-6v-850mah-lithium-ion-aa-size-rechargeable-w-wire-leads/|supplier].
Search for ''14500 3.6V battery with wires'' to find other suppliers that may suit you better.
You may find that some have the battery but with one wire at each end and not coming out at one end only. This isn't a problem unless the wire is too short to reach the board or it means that the battery won't sit properly when fitted etc.
As for installation etc, first ''take photos of where the original battery's red and black wires are soldered onto the pcb board'' so that you have a reference of where to connect the new battery wires. Then you need to simply unsolder the wires of the old battery from the board and solder the wires from the new battery in their place.
Then partially reassemble and check if it charges OK, then disconnect and fully reassemble the trimmer and fully charge the battery before use.