Washer stops 2-3 times, all the cycle lights and the warm water flash. If I click the start button twice the machine unlocks and locks and then keeps going. I have already checked the water valves for blockage and used the smart LG diagnostic- nothing is “wrong”.
좋은 질문입니까?
평판: 553.8k
11
426
1.6k
Hi @jonthn93783
Go to p.30 in the service manual and run the machine in service mode and check if that shows if anything is wrong.
이 답변이 도움이 되었나요?
The problem has persisted…I have tired to ohm out the water inlet valves (all seem to be fine), the LG app produced an IE error when I conducted the sound test, but verified no kink in water hose or lack of water pressure. The cycle only runs for about 5 minutes…usually after the initial tub is filled with water. Any ideas? I’m not sure a technician can troubleshoot further without replacing random parts?
Just verifying that no errors were shown when running the washing machine in service mode as described in the service manual?
평판: 7.9k
5
6
2
An unbalanced load will give an error and only happens during the spin cycle if it can't rebalance by filling with water. A faulty door switch or loose connector to it, might be causing this.
이 답변이 도움이 되었나요?
지난 24시간: 0
지난 7일: 5
지난 30일: 27
전체 시간: 237
