주요 콘텐츠로 건너뛰기
도움말
5단계 편집 중 —

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 21개에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

For this step, you only need to move the connector about 2 mm. Pulling too hard or too far will damage the connector.

Loosen the trackpad connector by pulling the locking bar toward the battery housing, using the tips of your fingers.

Slide the trackpad cable out of the loosened connector.

When reattaching the trackpad ribbon cable, make sure that the orange cable is slid into the connector above the locking bar.

Note: When reassembling the case, the trackpad cable can get stuck below the slot to the motherboard. It's possible to nudge it out slowly by gently prodding it on either side with a small screwdriver. You don't need to use much force to do this. Eventually it will just pop back out and you can reconnect as per the instructions above. Also, note that the locking bar comes loose so if you see a little piece of plastic lying around when reassembling, that's what it is. :)

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.