주요 콘텐츠로 건너뛰기

Headset Adjustment

3 단계
Headset Adjustment: 0 단계, 이미지 2개 중 1개 Headset Adjustment: 0 단계, 이미지 2개 중 2개
  • Torque the bearing preload adjustment bolt on your stem cap just enough so that the knocking goes away.

  • Torque required is usually in the 2-3nm range.

  • If the steering feels rough or sluggish after tightening down the headset bearing preload bolt when turning your handlebars from side to side, you’ve over-tightened the headset.

  • Back it off an eighth or a quarter of a turn and check it again by turning the handlebars from side to side and pulling the front brake and rocking the handlebars front to back to feel for any knocking.

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.