You might of burned up the motor.Call customer service do not tell them about the water just what the sweeper is doing

Did you find the issue my shark sweeper is doing that microswitch or the brushroller motor could be the culprit

It's not in right mine was doing that until I realized i was doing it wrong

Check your microswitch it runs the headlights also

If you have the soft roller brush on the side by soft roller there's a slide button slide that the soft roller should come out.The bigger roller should have like a gray piece sticking up on the end pull up on it the roller cones out.Goodluck to you

Check on ebay there is alot of shark sweeper parts there and also Jimmys.com

I'm having the same issue shark duoclean liftaway NV801.I tore it apart bypassed the microswitch but ended up being a good switch.So I checked the belts they are good someone said it could be the brush roller motor.Its a pain to get apart and I used a small flat head screwdriver cause security screws are everywhere to take out

I have a shark duo clean lift away Model#NV801QBN.I went to run the sweeper the red light was on I cleaned everything the red light went out but no green light either.Head lights works Customer Service stated the floor head is bad from just sitting? I sweep 1x weekly its just me here

My shark is doing that actually just happened I called customer service the lady told me the floor head needs replaced which they no longer have for my model.Im not believing that's the problem I sweep 1x aweek it's just me so from sitting the red light came on very strange

Did it work? My shark duoclean lift away the red light came on cleaned everything the red light went out but no green light came on the brush barely moves