내 작업대

기기에 대한 안내서, 부품 및 답변에 신속히 접근할 수 있습니다

MacBook Pro 13" Unibody Early 2011 Hard Drive Cable Replacement

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

안내서로 돌아가기

영어

한국어

6 단계 번역중

6 단계

MacBook Pro 13" Unibody Early 2011 Hard Drive Cable Replacement: 0 단계, 이미지 3개 중 1개

MacBook Pro 13" Unibody Early 2011 Hard Drive Cable Replacement: 0 단계, 이미지 3개 중 2개

MacBook Pro 13" Unibody Early 2011 Hard Drive Cable Replacement: 0 단계, 이미지 3개 중 3개

Your replacement part may or may not come with the front (sensor) bracket. If it does not, you'll need to transfer it to your new cable.
Use the tip of a spudger to flip the "lever" of the ZIF connector (left side in first photo) on the hard drive cable. The connector does not come off, see next instruction.
Gently pull the yellow sensor bracket cable out of the ZIF connector (to the right, in the second photo).
Use the flat end of a spudger to pry the hard drive cable up off the sensor bracket to which it is adhered.
Remove the adhesive backing from your new hard drive cable, stick it onto the sensor bracket, and connect the sensor bracket cable.
Many fixers cover the length of the thicker cable in the pair with sections of electrical tape on both sides because it can rub the tiny ridges inside the aluminum case causing a short to the case itself or simply breaking the connection.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.