주요 콘텐츠로 건너뛰기

iMac G5 20" Model A1076 Optical Drive Replacement

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 3개에 영향을 미칩니다.

2 단계 번역중

2 단계
iMac G5 20" Model A1076 Optical Drive Replacement: 0 단계, 이미지 2개 중 1개 iMac G5 20" Model A1076 Optical Drive Replacement: 0 단계, 이미지 2개 중 2개
  • Pull the optical drive up by its white pull tab to disconnect it from the logic board.

  • Lift the free end of the optical drive just enough to clear the fan cover. Lifting the free end of the optical drive too far may break the plastic positioning pins off the front bezel.

  • Lift the free end of the optical drive slightly, then pull it away from the edge of the rear case to clear the two plastic positioning pins.

  • Lift the optical drive out of your iMac.

  • When reinstalling your optical drive it may be necessary to set the bezel attached to the open end of the drive on the plastic positioning pins molded into the front bezel of the iMac and pull the connector side of the drive toward the edge of the rear case, bending it outward slightly, to properly seat the connector.

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

여기에 번역 삽입

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.