주요 콘텐츠로 건너뛰기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 41개에 영향을 미칩니다.

1 단계 번역 중

1 단계
In this step you will disconnect the battery to help avoid shorting out any components during service. Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.
  • In this step you will disconnect the battery to help avoid shorting out any components during service.

  • Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.

  • Bend the battery cable slightly away from the logic board so the connector will not accidentally bend back and make contact with its socket.

作業中に部品がショートするのを防ぐためにバッテリーを取り外します。

スパッジャーの平面側先端を利用し、バッテリーコネクターを持ち上げてロジックボードのソケットから外します。

ロジックボードから外したコネクターのケーブルをわずかに曲げて、コネクター部分が誤ってソケットに接触しないようにします。

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.